电子测量复习（Electronic measurement review）.docVIP

电子测量复习（Electronic measurement review） Fill in the blanks 1, in the choice of instruments for measurement, should be as small as possible to reduce the indication error, generally should show that the indication value in the instrument full scale value of more than ___2/3__ region. 2, the size of random error can be used to measure value ____ ____ standard deviation to measure, the smaller the value of measured value, more concentrated, ____ precision measurement of the higher ____. 3, set the signal source preset, the output frequency is 1MHz, in 15 minutes, the maximum frequency is 1.005MHz, and the minimum value is 998KHz, then the short frequency stability of the signal source is ___0.7%___. 4. The core part of the signal generator is the oscillator. 5 、 the sine wave formation circuit in the function signal generator is used to transform the triangle wave into sine wave. 6) the sampling oscilloscope uses non real time sampling technology to expand bandwidth, but it can only observe repeated signals. 7, when the observation signal two low frequency, can be used to avoid flicker dualtrace display ____ intermittent ____ way. 8, BT-3 type frequency characteristic tester, frequency marker is labeled with some form of graphics frequency axis quantitatively, the common frequency with ___ needle frequency standard _____ and ____ diamond _____ frequency standard. 9 、 logic analyzer according to its working characteristics can be divided into logical state analyzer and logic timing analyzer. 10, the pointer type voltage meter and digital display voltmeter to measure the voltage of the analog __ belong to ____ ___ ___ digital measurement and measurement. 1 measurement error is the difference between the measured result and the true value. Generally can be divided into absolute error and relative error. 2, when the measured data are normal distribution, if the number of measurements is enough, it is customary to take the 3 Sigma as the boundary to distinguish the abnormal d