汇编语言指令大全最新发布完整版（Assembly language instruction Daquan, the latest release of the full version）.docVIP

汇编语言指令大全最新发布完整版（Assembly language instruction Daquan, the latest release of the full version） Assembly language instructions Daquan the latest release of the full version of.Txt48 smile, is a green in spring, is under the sun hungry a shade, autumn is a cool breeze, a winter campfire. Smile and face it, you will feel that life is so warm. Data transfer command - - - - - - - - - - - - - - - - - - - - - - - - - - -- They transfer data between memory and registers, registers, and between input and output ports 1. general data transfer instructions MOV transfers words or bytes MOVSX first symbol extension, and then transfer MOVZX first zero extension, and then transfer PUSH presses the word onto the stack POP pops up the word stack PUSHA presses AX, CX, DX, BX, SP, BP, SI, DI in the stack in turn POPA pops up the stack in DI, SI, BP, SP, BX, DX, CX, AX, in turn PUSHAD presses EAX, ECX, EDX, EBX, ESP, EBP, ESI, EDI in the stack in turn POPAD pops up the stack in EDI, ESI, EBP, ESP, EBX, EDX, ECX, EAX, in turn BSWAP switches the order of bytes in a 32 bit register XCHG exchange byte or word. (at least one operand register for * *, * * segment register can not be used as the operand) CMPXCHG compare and swap (second * * * * operands. Operand must be AL/AX/EAX accumulator) XADD exchange adds. (results in the first operand in * *) XLAT byte look-up table conversion - BX points to the starting point of a 256 byte table, and AL is the index value of the table (0-255, that is, the index value of the table 0-FFH) returns AL as table look-up result ([BX+AL]-AL) 2. input and output ports transmit instructions IN I/O input port. (Syntax: IN accumulator, {port number / DX}) OUT I/O port output. (Syntax: OUT {DX}, port number, accumulator) The input and output ports are specified immediately, with a range of 0-255; specified by the register DX, Its range is 0-65535. 3. destination address transfer instruction LEA loads valid addresses Example: LEA, DX, string; saves the offset addres