混凝土塌彤（Concrete collapse）.docVIP

混凝土塌彤（Concrete collapse） 1.2, steel cage collapse hole in the sinking steel reinforcement skeleton will also produce hole wall collapse, the cause of the collapse may be reinforced cage transfer too hard or reinforced steel frame verticality is not good or cause bending. Therefore, in the reinforcement of the steel skeleton should be particularly careful, reinforcement cage transfer speed should be slow, the upper and lower two welding should be in the same axis position, and always observe the water level in the hole. Once the wall collapse, the water level in the hole will change. After the sinking of steel framework collapse, generally available for pouring concrete duct with sand pumped from the muddy waters of the mud, you should pay attention to the pump pressure can not be too large, so as not to aggravate the damage of drilling. 1.3 concrete pouring hole in concrete pouring process if found support level in the barrel of a sudden rise in mud and overflow tube, then drop and bubble phenomenon, it is estimated the collapse hole, available detector probe, if the surface depth measured by the detector is not up to the original depth is can be concluded that the occurrence of hole collapse. The hole collapse reason may be Water Leakage around the tube bottom hole, the water level dropped or the river water level rose, pore water level difference decreases, can not maintain the original hydrostatic pressure, and the casing around the pile loads or mechanical vibration etc.. Once the collapse hole, should immediately identify the causes and take appropriate measures, such as to maintain or increase the head, remove and eliminate the heavy vibration. Then the suction machine suction hole in the slump mud mud, hole collapse if the stop, you can continue to pour concrete, if it continues to collapse, and hole collapse at the site of the deep. We should pull the guide tube, the concrete drill out, and reinforced cage, and clay mixed with gravel backfill. The heavy back