液压1（Hydraulic 1）.docVIP

液压1（Hydraulic 1） 1., in order to prevent the hydraulic pump producing cavitation, the absolute pressure in the pump suction chamber should be greater than (B). A. an atmospheric pressure B. air separation pressure C. saturated vapor pressure D. absolute vacuum 2. the operating pressure of the hydraulic system depends on (A). A. load B. pump suction oil port pressure difference C. pump rated pressure D. relief valve setting pressure 3. (B), the system efficiency is higher. A. throttling speed control, B. volume speed control, C. volume one throttle speed control, D. change motor speed regulation 4. if the hydraulic cylinder is required to stop accurately and the hydraulic pump is unloaded after stopping, then the reversing valve in the reversing loop shall be selected (D). Type B.H, type C.P, type D.M, type A.O 6. in order to pulsation reducing single action vane pump rate, the blade (C). A.. Leans forward, B. leans backward, C. takes odd numbers, D. takes even numbers 7., in large load, power occasions often choose (A). A. piston pump, B. double acting vane pump, C. gear pump, D. limited pressure variable vane pump 10.L-HL22 ordinary hydraulic oil indicates that the average kinematic viscosity of the oil at 400C is (D). A.22m2/s B.22dm2/s C.22cm2/s D.22mm2/s 11. pilot relief valve set pressure of P1, its remote control of remote pressure regulating valve is P2, The following (C) statement is true. A.P1 has nothing to do with P2; B.P1P2 C.P1P2 D.P2 does not work 12. the main factor limiting the increase in gear pump pressure is (C). A. flow pulsation, B. trapped oil phenomenon, C. leakage, D. noise 13. hydraulic pump uses auxiliary low-pressure system to supply oil to the pump. Assuming the pump speed, efficiency and external load are unchanged, the pump output power (B). A. increases B., decreases C., constant D. may increase, and may decrease 14. the inlet pressure is greater than the setting pressure of the pressure reducing valve, and the outlet pressure is relat