浅谈模切工艺（Die cutting technology）.docVIP

浅谈模切工艺（Die cutting technology） Die cutting technology The cutting process is a process of the most commonly used packaging printing to the cutting knife is used according to the requirements of product design drawings into the die, under pressure, will be printed or other sheet blank rolling forming process into a desired shape or cut marks. Creasing process is to use a knife or a wire pressing mold, through the pressure on the sheet extrusion line, or the use of rolling reels in sheet rolling outlet on the mark, to the sheet can be bended at a predetermined position. Usually die-cutting process is the die cutter and line knife combination in the same template, in the die-cutting machine at the same time die cutting and indentation process, referred to as die cutting. Process introduction: die cutting indentation of the main process is: the last version to adjust the pressure to determine the rules - to paste rubber tape test pressure die cutting - formal die cutting indentation - cleaning waste to finished product inspection - point packaging. Version First of all, proofread the already done die cut, and see if it meets the requirements of the design draft. Steel wire (wire cutter) and steel (cutting) position is accurate; the slotted opening rounded whether to adopt the whole line, line bends is the corner of the garden; in order to facilitate the waste, the adjacent waste of the connection is narrow side increases the connection part, make it into a block; at the head of whether sharp corners the two lines of the middle section; whether there is pointed to another straight line by the situation. Once the die cutting plate appears the above problems, we should notify the plate maker to correct it immediately, so as to avoid wasting more time. Then, the production of die - cutting version, installed in the die - cutting machine version of the box, the initial adjustment of the position of a good version. Adjust the pressure, make sure the rules and stick the rubber