现浇箱梁（Cast-in-situ box girder）.doc

现浇箱梁（Cast-in-situ box girder） The construction scheme of continuous box girder is now pouring 1. Design introduction This bridge upper structure for the 4 hole a league (4 x 25 m) cast-in-situ prestressed concrete box girder, beam high of 1.40 m, 1.0 m high box office, bridge span 100 m, 15.0 m wide, about double, single width 7.5 m, the beam bottom width 3.75 m. Of this bridge and main into orthogonal plane in the straight line segment, after A few located at 60, R = A = 60 m easement curve segment, longitudinal located in longitudinal slope + 3.8%, 2.4%, the vertical curve radius R = 2000 m on the vertical curve of bridge deck with bi-directional cross slope 2%, bridge deck transverse slope with box girder integral spin and become. The bridge deck adopts the single double GPZ3DX basin type support, the pier no.2 pier adopts the piers consolidation, and the 1st and 3rd pier adopts single GPZ6DX basin type support. Under the bridge, the geological conditions are 4 m thick subclay, 5 m thick clay pebbles, siltstone and so on. 2. Overview of construction plan (1) support base To clean up, can the construction of bridge site leveling, backfill slag down 1 m, compaction, and then use filling to beam down slag powder sandstone under 1 m, when the filling layer paving compaction, layering thickness of 40 cm, when filling pile embedment subsidence for settlement observation, once every three days of observation, after a month until the filling is complete, and three times each settlement is less than 3 mm, and unload 1 m, leveling, rolling, tested in accordance with requirements after the last 10 cm thick cobble laid, casting 10 cm thick concrete C20 element as a support base. See figure 1 for details. (2) the stent was set up According to the design scheme, the construction of the manchuang stand is used, and the construction is carried out before and after the construction. In the bracket after the completion of the foundation construction of box girder bracket lofting,