检测方法（Detection method）.docVIP

检测方法（Detection method） Once the oxygen sensor failure, will make the electronic fuel injection system of the computer cant get oxygen concentration in the exhaust pipe of information, so cant feedback control of air-fuel ratio, can make the engine fuel consumption and exhaust pollution increase, engine, unstable idle speed of fault phenomena, the surge of fire. Therefore, failure or replacement must be eliminated in a timely manner. Once the oxygen sensor failure, will make the electronic fuel injection system of the computer cant get oxygen concentration in the exhaust pipe of information, so cant feedback control of air-fuel ratio, can make the engine fuel consumption and exhaust pollution increase, engine, unstable idle speed of fault phenomena, the surge of fire. Therefore, failure or replacement must be eliminated in a timely manner. 1. Common failures of oxygen sensors are: 1. Oxygen sensor poisoning. Oxygen sensor poisoning is a frequent and difficult problem, especially with the use of leaded gasoline, even with new oxygen sensors, which can only work thousands of kilometers. If only mild lead poisoning is used, then a tank of unleaded gas can be used to remove the lead on the oxygen sensors surface, allowing it to resume normal work. But often because of excessive exhaust temperature, the lead intrudes into its interior, hindering the diffusion of oxygen ions, and the oxygen sensor fails, so it can only be replaced. In addition, oxygen sensor is often used in silicon poisoning. In general, after burning gasoline and lubricating oil containing silicon compounds generated silica, silicone rubber sealing washer, improper use of organic silicon gas can make oxygen sensor failure, and therefore to use good quality fuel oil and lubricating oil. Make sure to use and install rubber gaskets when repairing, do not apply to the sensor to apply other solvents and adhesion agents. 2. Carbon deposition. Because of bad engine combustion in oxygen sensor surface carbon, an