3第三章 化工工艺图 第二节设备布置图、第三节（3, third chapters, chemical process drawings, second sections of equipment layout, third sections）.docVIP

3第三章 化工工艺图 第二节设备布置图、第三节（3, third chapters, chemical process drawings, second sections of equipment layout, third sections） This article is contributed by Shen Wuming Ppt documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. The third chapter, chemical process diagram Section second equipment arrangement drawing Section second equipment arrangement drawing All equipment determined by the process design must be properly arranged and installed inside and outside the plant building according to the requirements of the manufacturing process. The design of the installation position of the equipment inside and outside the plant is called the equipment layout, which is used to guide the installation and construction of the equipment. It is also an important basis for the design of the piping layout and the drawing of the piping layout. First of all, introduce the basic knowledge of architectural drawing. First, the basic knowledge of architectural drawings, building plans are used to express architectural design and guiding the construction of the drawings. It will be the building inside and outside the shape and size of the various parts of the structure, decoration and equipment, according to the national standard of technical drawing and national construction standards (GBJ) provides accurate and detailed projection method is used to express the building diagram as shown in figure 3-9. (a) view A set of views of a building drawing, consisting mainly of plans, elevations, and sections. A plan is a cutaway view made by assuming that a horizontal plane is cut slightly above the window sill. A plan reflects the plane pattern of a building, the size of a room, walls, columns, doors, windows, and so on. It is the main view of a set of views in a building drawing. The construction plan construction plan is supposed with the level of the cutting plane by building door and window opening