Mn含量对FeNiMn合金热磁特性的影响 Effects of Mn Content on the Thermal Magnetic Properties of FeNiMn Alloys.pdfVIP

研究 分析 实验 Mn 含量对FeNiMn 合金热磁特性的影响 龙仲驰 张万里 彭 斌 蒋洪川 电子科技大学 电子薄膜与集成器件国家重点实验室 四川成都 610054 摘 要 采用真空熔炼方法制备了 Fe64Ni36 1 xMnx x=1, 2, 3, 4, 5% 热磁合金 系统研究了Mn 含量对 合金热磁性能的影响 结果表明 Mn 含量对合金的相结构影响很小 但显著影响合金的工作磁感应强度(Bm) 居里温度(T )和磁感应强度的温度变化率 dB /dT 随Mn 含量增加 B 和 T 均单调下降 dB /dT 先增大后 C m m C m 减小 在Mn 含量为2%时达到最大值 Mn 含量为3%的样品在20~ 160 内Bm-T 曲线线性度最佳 适合在该温 度范围内用于磁温度补偿 关键词 磁温度补偿合金 热磁特性 成分 中图分类号 TM274 文献标识码 A 文章编号 1001-3830(2007)01-0023-03 Effects of Mn Content on the Thermal Magnetic Properties of FeNiMn Alloys LONG Zhong-chi, ZHANG Wan-li, PENG Bin, JIANG Hong-chuan State Key Laboratory of Electronic Thin Films and Integrated Devices, University of Electronic Science and Technology of China, Chengdu 610054, China Abstract: Fe64Ni36 1 xMnx x=1, 2, 3, 4, 5% thermal magnetic alloys were prepared using vacuum melting method. Effects of Mn content on the thermal magnetic properties of alloys were systematically investigated. The results show that Mn content has no effect on the phase structure of the alloys, but the working magnetic flux density (B ), Curie temperature (T ) and the change rate of working magnetic flux density versus temperature (dB /dT) are m C m influenced significantly by Mn content of the alloys. Bm and TC monotonously decrease with the increase of Mn content. The value of dBm/dT increases to a maximum when Mn content is 2%, before decreases with further increase of Mn content. The sample with 3% Mn content has the best linearity of the Bm-T curve in the tempe