Chip classifier OpTest（芯片分类器选择）.pdf

Chip classifier This equipment classifies wood chips into different sizes, using screens. It plays an essential production management role in mak- ing chips, ensuring production of chips of a unified size required, which contributes to securing of adequate digestion through main- tenance of the chipper knife condition and efficient operation of the chip breaker and screens. It is also an important tester in com- mercial transactions that helps quality identification when pur- chasing wood chips. Screens of various types are assembled in the ascending order of the opening diameters. Chips are input into the screen with the largest opening first, and then they are vibra- ted to drop them through the screen to lower screens. Thus, chip specimens are classified by size to leave only small splinters col- lected in the bottom trash retainer at the end. You can check the distribution of chip sizes by weighing both the specimens left on the respective screens and in the trash retainer. Screen dimensions: 535 53570 mm Screen: select 5 kinds Opening diameter: 5 to 40 mm Amplitude: 120 mm Vibration frequency: 120/min. Referential standards: J.TAPPI No.4, TAPPI UM21 Power source: three-phase 200/220 VAC 50/60 Hz 5A Outer dimensions: 1755885980 mm Instrument weight: 300 kg Compact chip classifier Like the mode I, this equipment is also used for chips classifica- tion. Compact in size, this classifier provides superior operability. The screen box allows various combinations of holes with different shapes including round ones and slits. The box can also be moun- ted or removed easily. Screen dimensions: 500400 40 to 70 mm Material of screen box: aluminum Material of screen plate: SUS Kinds of screen: standard screen opening diameters 40 mm,