CYCLOPS STORM OSD V1.0manual Hobby （独眼巨人风暴OSD V1.0manual爱好）.pdfVIP

CYCLOPS STORM OSD V1.0 manual Thanks for buying and using CYCLOPS OSD series products, please read this manual carefully before use. Installation of connections Important: select Jumper instructions: 1, 2 short circuit for using power batteries(which must be 12V, or 3S Lipo batteries); remove the jumper cap, and connect 2 and 3 to power up OSD and wireless video equipments separately with additional 12V power supply. When mounting OSD main board to the aircraft, please check whether the position is installed correctly, namely the nose of the small white plane design on the main board points to the direction of the aerial carriers nose. Current sensor wiring Diagrams (with a T plug ) System parameter setting Connect the GPS module and OSD correctly according to the above instructions, switch on the power, the red light on the OSD main board flashes, then it will enter the following boot interface: Press the “UP” and “DOWN” buttons on the switchboard at the same time to enter the main menu settings. Press the UP and DOWN can move the cursor, OK button used to confirm the options. Menu setup instructions Options Setup instructions Comments When the power consumption reaches the set value in flight, the BAT SCALE mAh alarm value battery capacity symbol and value will flash to indicate it. RESET Reset the current At first use or after replacing the current sensor, it needs to set CURRENT sensor to zero this option Please make a test flight of the model aircraft test and adjust the CENT Servo center center point of the control surface before c