Cylinder Head and Block Leak Analysis Method （汽缸和块泄漏分析方法）.pdfVIP

Cylinder Head and Block Leak Analysis Method When servicing an MBE 4000 engine, have you observed the following conditions? Click the following graphics to identify the root cause. Coolant color or white ash Head gasket vent hole witness mark Leaking cylinder head cup plug Identification of failure: The coolant vent line leak is often misdiagnosed as a head gasket leak. The coolant vent line is attached to the center top of each cylinder head and is very difficult to see behind the EGR cooler and EGR cooler bracket. However, any leakage from this coolant vent line will show near the head-to-block joint and down the side of the block. Root Cause Solution / Correction What To Do Next Install missing washer (refer to the EPA07 MBE 4000 Read 09 TS-9 in its entirety - Missing Workshop Manual or Power Service Literature /cps/rde/xchg/ddcsn/hs/4445.htm washer /power_service/literature/Con tent/C1/C10203.htm ) Check banjo bolt torque (refer to the EPA07 MBE 4000 Read 09 TS-9 in its entirety - Banjo bolt Workshop Manual or Power Service Literature /cps/rde/xchg/ddcsn/hs/4445.htm torque is /power_service/literature/Con incorrect tent/C1/C10203.htm ) Replace the coolant vent line (refer to the EPA07 MBE Read 09 TS-9 in its entirety - Cracked weld 4000 Workshop Manual or Power Service Literature) /cps/rde/xchg/ddcsn/hs/4445.htm at banjo bolt /power_service/literature/Con fitting tent/C1/C10203.htm ) Return to home page Identification of failure: Ofte