实务06—10（Practice 6-10）.docVIP

实务06—10（Practice 6-10） 1. Level of concrete structure environment: (new) see P8 table 2a311012-3 2. Requirements for concrete durability: the minimum strength level of concrete to meet the durability requirement (new) see P8 table 2a311012-4 3. The thickness of concrete cover: requirement, use fixed number of year for 50 years of reinforced concrete and prestressed concrete structures, the longitudinal stress of reinforced concrete protective layer thickness should be not less than the nominal diameter of steel bar, usually is 15 ~ 40 mm. Typical type: 1. The normal design of the structural components that are easy to replace is () years 10 A. B. 25 50 C. 100 D. The design and use of architectural structure has been put forward in our country. Please refer to the table below. Class design years (year) sample 1 5 temporary structure 2 25 easy to replace structural components Ordinary houses and structures 4 100 commemorative buildings and particularly important architectural structures Answer: B 2. The following are the crack control grades of concrete structures (BCD) A. Members are not subjected to any force B. the component does not appear tensile stress C. Although the component has tensile stress, it does not exceed the tensile strength of concrete D. Cracks shall be allowed, but the width of the crack shall not exceed the allowable value E. Cracks are allowed and the width of the crack is unlimited 3. The same length of pressure bar, the cross-sectional area and the material are the same, except for the different supporting conditions at both ends, the critical force of the (D) bar is the largest. A. Hinged branches at both ends B. Fixed at one end and free at one end C. one end is fixed and one end is reamed D. fixed at both ends 4. The maximum deformation f (D) of the cantilever beam with uniformly distributed load increases by 1 times. A. It will increase to four times B. It will increase to 8 times C. Will increase to 12 times D. Will increase to 16 times 2