塑料加工成型过程中遇到的问题(注塑成型不良（Encountered in the process of plastic injection molding problems (bad）.docVIP

塑料加工成型过程中遇到的问题(注塑成型不良（Encountered in the process of plastic injection molding problems (bad） Encountered problems in the process of molding of plastics injection molding (bad.Txt I grudge bully, which can let others bully? Life is so long, so what I love you is a few years I want to personally give her happiness to others I am not sure I think of you when I have to find you. You are not allowed to bully him! The whole world only I can! Give up you, next life!! Encountered problems in the process of plastic processing molding (injection molding defect) Injection molding is bad We believe that you in the injection molding process is more or less encountered many problems, such as dissatisfaction, flash, table The size change of defects such as surface depression. These defects may be caused by mold design, injection molding machine precision, can also be Is the operator does not grasp the proper process conditions caused by. The varied factors, perplexing, and Mutual influence. Here, we have consulted various related professional and technical personnel, collected at home and abroad to solve such defects in hope You can improve the injection molding in the production process, the yield of help, this is our sole purpose. In view of influence Forming too many factors and related solutions, the company released, for your reference. Bubble The reason that related technology and equipment may 1. cylinder temperature is too high 2. injection pressure, back pressure is too low. 3. pressure (lack of time) 4. speed is too high 5. filling material shortage The 6. tube temperature setting bad The reason may be associated with die 1. thick wall (reinforcement) Wen Taigao The 2. gate or bad channel 3. types of gate or bad location The 4. gate early solidification The 5. bar is too thick 6. the mold temperature is too low 7. bad exhaust The reasons related to materials may 1. the material flow and shrinkage of undesirable 2. feed back too much 3. of the raw material is not fully dr