电路设计的九个阶段（The nine stage circuit design）.docVIP

电路设计的九个阶段（The nine stage circuit design） Nine stages of analog circuit design Phase one You just entered this line, to what PMOS/NMOS/BJT just have a rough understanding of characteristics of various devices, you dont know, what kind of specific design into the circuit you have no idea what you see, circuit diagram of the main domestic magazine, ready-made circuit textbooks, you find them have a point. You do the circuit is mainly small scale modules, do point difference op amp, band gap baseline simulation, what you calculate the hair article, for fear that the time enough. In general, basically see the amplifier or timid. You think spice is a very difficult and weird thing to use. Second stage You begin to know what circuit design is, and you are holding a textbook every day. You also often start talking about technical parameters such as Vdsat, lamda, early, voltage, GWB, FT, and so forth. Always feel that sometimes the circuit is almost the same as the hand, and sometimes feel very different. You also begin to care about voltage, temperature, and process changes. For example, low voltage, low power systems, or something. Is super high-speed, high-precision what Dongdong, from time to time also come two sentences. When you design the circuit, you start planning to go to tape out, although the tape out looks pretty far away. Stage, you think spice is very powerful, but often AC simulation results wrong and big headache. Third stage Youve been struggling with PVT for some time, but basically there hasnt been a few successful design experiences. You think its really hard to design a circuit that really works. Youre anxious to build up your confidence, but you dont know what to do. You started reading something about Dr. JSSCs paper, but you think theyre talking about the same thing, the real chip isnt that. What do you think of the Vdsat index is not accurate enough, the default emulator is not enough to meet your requirements, then you try to simulator parameters,