杜龙（Du long1）.doc

杜龙（Du long1） Density test (sand filling method) First, the purpose and scope of use This test is applicable to the determination of grass in the field (or base), density and degree of compaction of gravel soil compaction layer materials of subgrade soil, density and compaction of surface treatment, Yu Luqing also used asphalt penetration pavement layer, but not suitable for rock fill embankment with large holes or compaction test porous material. When the density and compactness are measured by digging sand filling method, the following requirements shall be met: (1) when the maximum particle size of the base material is less than 15mm and the thickness of the test layer is not more than 150mm, a small sand filling barrel of 100mm diameter shall be used for testing. (2) when the maximum particle size is equal to or greater than 15mm, but not greater than 40mm, and the thickness of the measuring layer is more than 150mm, but not more than 200mm, the large sand filling barrel with diameter 150mm is tested Two. Instruments and materials Sand filling barrel, metal calibration tank, substrate, sand (particle size 0.30 ~ 0.60mm or 0.25 ~ 0.50mm, clean and dry uniform, sand 20 ~ 40g Three, methods and test steps 1. Demarcate the quality of the sand in the cone at the bottom of the sand filling tank 2. The unit mass of sand is standardized 3. The sand filled barrel with M5 is placed on the round hole in the middle of the substrate, and the switch of the sand filling barrel is opened to allow sand to flow into the hollow of the substrate until the sand is not flowing. Remove the sand filling tube, said the quality of cylinder sand (M6), accurate to 1G. 4. Take the total mass of all the materials in the test pit Mw. 5. Take representative samples from all the excavated materials and determine their water content (omega,%). The sand tube was measured by small irrigation, soil is not less than 100g in the soil is not less than 500g; with a large sand barrel, the fine grained so