混凝土碳化深度的检测与评定（Detection and evaluation of concrete carbonation depth）.doc

混凝土碳化深度的检测与评定（Detection and evaluation of concrete carbonation depth） This paper contributed by lilongsi123. Doc document may at the WAP end of the browsing experience poor. Suggest you select TXT, or download the source file to the machine view. The results of 8.1.1 steel corrosion potential test of concrete carbonation depth and evaluation of railway engineering quality inspection 8 structure of the 8.1 detection methods showed that the reinforcement may be corroded in the area, should carry on concrete carbonation depth measurement. Detection of 8.1.2 in concrete carbonation is usually used in the coagulation of fresh section through the observation of spraying pH indicator; pH indicator color change to determine the depth of carbonation. The selection principles of 8.2.1 measurement in 8.2 position detection steps may refer to the corrosion of natural potential test requirements, if in the same area, should be measured and the corrosion potential and resistivity measurement and protection, carbonization depth and chloride ion content. 8.2.2 test area and test hole (1) test area should include the corrosion potential measurement results are representative of the region, also can reflect the different conditions and different parts of the quality of concrete structure, the outer side should be arranged in survey area. (2) the number of test area should not be less than 3. The test area should be uniform layout. (3) for each test area should be arranged three measuring holes, three holes should be measured in the goods character arrangement, hole spacing is determined according to the component size, but should be more than 2 times the aperture. (4) the distance measuring hole edge what distance should be more than 2.5 times the thickness of the protective layer. 8.2.3 the use of acid-base indicator spray in fresh concrete damaged surface, according to the change of the color of the indicator, the concrete carbonation depth measurement, measurement accuracy to mm.