第三章 单分型面注射模（The third chapter is the injection mold of single parting surface）.docVIP

第三章 单分型面注射模（The third chapter is the injection mold of single parting surface） The third chapter single parting surface injection mold First, the basic content of this chapter This chapter includes the overall structure of the plastic injection mold design; function and design method of each component single parting surface injection mold; plastic parts plastic injection mold; design of gating system; calculation of molding parts size; simple introduction mechanism design; temperature control system; the structure of mold parts design; design steps and design method of single parting surface injection mold. A single injection mold surface composition and working process The parting surface A single injection mold surface Gating system design Forming parts design Launch mechanism design The temperature control system design Two, learning objectives and requirements Through the study of this chapter, should the general design process and method of organization launched the overall structure and gating system, master the single parting surface of injection mold. The three chapter, the key points and difficulties: Single parting surface injection mold structure and gating system, the agency launched the general design process and method, temperature control system design. 1, single parting surface injection mold According to the mechanism, a single parting surface injection mold by mold, molding parts, injection system, guide mechanism, ejection device, temperature control system and structure parts. (1) die cavity Part of the cavity mold for molding plastic articles, because the mould cavity is directly molded plastic parts, so the shape of the cavity shape should be consistent decay of plastic parts, consisting of cavity by cavity core. (2) forming parts A plastic mold cavity parts called molding parts, usually includes the type (plastic molding internal cavity (shape), molded plastic outer shape). (3) gating system The plastic injection machine nozzle to flow from th