第二章化工设备常用的表达方法（The second chapter is the general expression method of chemical equipment）.docVIP

第二章化工设备常用的表达方法（The second chapter is the general expression method of chemical equipment） This article is contributed by czhk370784 Ppt documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. The second chapter describes the common methods of mechanical parts 2.1 view A basic view, the formation of the main view overlooking the map??? Left view? Right view from right to left projecting upward from the bottom up? Map projection view from the back to the front projection? Start the six projection plane Look up to the Lord Overlooking The projection correspondence between six views of the 3. Front, upper, right, lower, left, right, rear, high, main, left, right, right, rear, long, left, upward Still abide by the three? Correspondence: correspondence measure still abide by the range three rule:? Relationship in range of view, in addition to the view, close to the main view while the object is in front of the back side of the object. The back, away from the main view, is the front of the object. Six views are not used, but in the expression of parts, and not the six views are used, in the expression of parts is not six views with number of selection should be based on the actual situation. But when the parts of a shape in a view has been expressed clearly, and the solid line, if this part was clear in other regards, and solid, if this part in other view projection map projection is a dotted line, dotted line, the line can be omitted. Two, to the view Views are freely configurable views B, C, E, D, C, F, F, D, E, B Configuration by base location Free allocation In view of the above annotation to the letter, in the corresponding view near the arrow in the direction view above the head annotation letters, indicating the direction of projection head, indicating the direction of projection, and marked with the same letter. Three a partial view is a view that is projected from one part