造价班16组—名字·太俗(第三章 混凝土结构材料的力学性能)_百度...（Cost 16 - class group name, too (the third chapter material mechanical properties of concrete structure _ Baidu)...Three）.docVIP

造价班16组—名字·太俗(第三章 混凝土结构材料的力学性能)_百度...（Cost 16 - class group name, too (the third chapter material mechanical properties of concrete structure _ Baidu)...Three） This article is contributed by the people who live for dreams Ppt documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. The name is too vulgar Third chapters Mechanical properties of concrete structural materials Verse 1 A steel bar First, the strength and deformation of reinforced concrete structure of the steel used in two categories: the physical yield point of steel and no physical yield point of reinforcement. 1. stress-strain curve of reinforced bar Figure 1-2a stress-strain of reinforced bar with apparent yield point Figure 1-2b stress-strain curves of bars with no apparent yield point In the calculation of reinforced concrete members, the yield strength of steel bars is usually taken as the strength index. The typical stress-strain curve of the steel bar without apparent yield point is shown in figure 1-2b. It can be seen from the diagram that there is no obvious yield plateau, but the strength is high, but the elongation decreases greatly and the plasticity decreases. The stress corresponding to the residual strain of 0.2% is designed to be the nominal yield strength Figure 1-2c stress strain curves for bars at all levels. Can be seen in the figure, the ordinary reinforced stress-strain curve has obvious yield point, which is also known as the steel of low carbon steel, mild steel. No obvious yield point bar and steel wire heat treatment, called steel. The ratio of stress to strain at the elastic stage is called the modulus of elasticity: Sigma s Es = epsilon s Cold processing of reinforcing bar In order to save steel at normal temperature has obvious yield point of steel (mild steel) for cold machining, can make the steel internal organization structure changes, so as to improve the strength of steel, but th