钢筋工程构造监督检查应注意的几个问题（Several problems that should be paid attention to in supervision and inspection of reinforcing steel structure）.docVIP

钢筋工程构造监督检查应注意的几个问题（Several problems that should be paid attention to in supervision and inspection of reinforcing steel structure） It is an important measure to ensure the quality of the main project that the concealed inspection and acceptance of the reinforcing steel bars are carried out. But in practice, the number and spacing of the quality inspection personnel tend to check steel structure of steel, ignore, and rework phenomenon have occurred, or omissions may remain hidden to the engineering and project quality accident caused by. Under the 1 rib dislocation problem of reinforced concrete rectangular plate column Under the action of the base net reaction, the bottom plate is bent in two directions, but the long side moment is larger. Therefore, the long side of the tendons should be placed under the short side of the tendons. But in the actual construction, the inversion has happened frequently. 2 、 the bending of the lower end of the cast-in-place column is offset by longitudinal stress bars This problem is a common quality problem in construction. The greater the horizontal distance of the steel bar is, the greater the slope is, and the greater the shear force of the curved longitudinal reinforcement when the force is applied to the column root, which leads to cracks in the concrete at the column root. For this reason, the following should be done according to the magnitude of the offset of the longitudinal reinforcement. (1) longitudinal bar deflection is small, the lower reinforcement according to the angle of slope (slope) using 1/6 gently bend to the column after colligation. (2) the longitudinal reinforcement offset is larger and has become a bow, rework difficult, with the consent of the design units, the lap length range, lashing Phi 8 encryption stirrups, and the concrete strength of the length range of the first order, in order to increase the tensile strength and the concrete and steel bar bending at the concrete bond strength. In the additional co