钢筋计算规则（Reinforcement calculation rule）.docVIP

钢筋计算规则（Reinforcement calculation rule） Reinforcement calculation rule Rules for calculation of reinforcement quantities (1) Rules for calculation of quantities of steel reinforcement 1, steel works, should be distinguished from cast in place, prefabricated parts, different steel grades and specifications, according to the design length multiplied by the weight of units, tons of computing. 2, when calculating the amount of steel works, the design of the length of the steel tower has been specified. According to the length of the tower, the length of the tower is not included in the design, and it is not included in the calculation of the length of the tower. Reinforcement, electroslag pressure welding, sleeve extrusion and so on, in order to calculate. 3, pre tensioned prestressed reinforcement length is calculated according to the shape and the size of the component, post tensioned reinforced by prestressed reinforcement design provisions of the reserved channel length, and the difference between different types of anchorage, were calculated according to the following provisions: (1) when using the screw anchor at both ends of the low alloy steel bar, the prestressing steel bar is reduced by 0.35m by the reserved hole length, and the screw rod is calculated separately. (2) one end of the low alloy steel bar is inserted with an end plug, and the length of the prestressed steel bar is calculated according to the reserved hole length at the other end of the screw anchor, and the screw is calculated separately. (3) one end of the low alloy steel bar is inserted with an end piece and the other end of the bar is supported by a bar; the prestressed steel bar is increased by 0. 15m, and the prestressed steel bar is increased by 0.3m at both ends with the help bar anchor. (4) the length of the prestressed steel bar is increased by 0. 35m after adopting the post tensioning silicon self anchoring for the low alloy steel bar. (5) low alloy steel or steel strand adopts JM, XM an