地大《画法几何与工程制图》在线作业一（Da Da descriptive geometry and Engineering Graphics online homework）.doc

地大《画法几何与工程制图》在线作业一（Da Da descriptive geometry and Engineering Graphics online homework） Da Da descriptive geometry and Engineering Graphics online homework Total score: 100 test time: - Radio examination A multiple-choice question Radio examination questions (17 questions, 68 points) 1. a curved surface formed by the movement of a bus line parallel to a wire and is called: () A. cylinder B. sphere C. ellipsoid D. cone Full marks: 4 2. for drawing convenience, generally take p=r=1, q=0.5 as positive two test () A. coefficient B. deformation coefficient C. simplified axial deformation coefficient D. axial deformation coefficient Full marks: 4 3. when drawing a line, which object capture option is used to select points in a line or multi line, so that two lines intersect at 90 degrees A. quadrant point B. appearance intersection C. nearest point D. intersection Full marks: 4 4. the national standard stipulates that the Chinese characters are 1.8, 2.5, 3.5, 5, 7, 10, 14, and (b) A. 16 B. 18 C. 20 D. 25 Full marks: 4 5. () refers to our country in the vicinity of Qingdao near the average sea level of the Yellow Sea is plus or minus points, and other height measurements. A. baseline elevation B. zero elevation C. absolute elevation D. relative elevation Full marks: 4 6. from the known master and top view, determine which view of the main view is correct A. a B. B C. C Full marks: 4 The relative position of the 7. space line and the projection surface has () species. A. 1 B. 2 C. 3 D. 4 Full marks: 4 8. dimension wire terminal form has () two form A. arrows and dots B. arrows and slashes C. circles and dots D. thick lines and thin lines Full marks: 4 9. in the process of motion of the surface according to a certain constraint, the generatrix moves to any position on the surface, called the surface A. wire B. prime line C. bus D. sub line Full marks: 4 10. what are the main methods of projection in this course? A. central projection method B. oblique projection method C. or