8800卡（8800 card）.docVIP

8800卡（8800 card） [DVRNET monitoring software remote settings instructions] 8800IP full set 8800 monitoring card to achieve remote connection The following content replies only then to be able to see ============================== The local routing address is: The local connection - attribute Internet protocol (TCP/IP) - properties Use the following IP address: 01 Subnet mask: Default gateway: Use the following DNS server address (Guangzhou) Preferred DNS server address: 43 Alternate DNS server address: 8 The settings for routing are: Forwarding rules - - Virtual Server ID service port IP address protocol enabled 180 01 ALL hook Forwarding rules DMZ host DMZ host IP address: 01 hook enable In order to apply the peanut shell domain name binding (also can use other dynamic IP parsing software) 8800 client and server connection settings Host control code: 100-001 Site name: 123 Password: 1234 8800 client and server connection settings Client settings: Install the client program directly after the operation, after entering the interface right click connect button, click add to add a new server in the pop-up box set. Group one uses the default value Remote site SITE Code, the host control code for the input server 100-001 SITE Name can be entered at any entry, but must be filled as the name of the connected server 123 In IP Address, enter the servers IP address (peanut shell domain name) 1234. In Password, enter the new password 1234 changed at the server side Confirm and enter the password again. One thousand two hundred and thirty-four After the completion of installation in the upper left frame in the Remote site drop-down list, select the connection you just created, then click add next to the connect button to connect Or enter the domain name 1234. in the IE browser address bar, IE will prompt the installation plug-in, select the installation, and then enter the remote monitoring login interface Control code is entered 100-001, password 1234 can. 2 reply: DVRNET