典型电动车窗控制系统的规则化描述建模.pdfVIP

合肥工业大学学报(自然科学版) Vo l. 36 No.8 第 36 卷第 8 期 2013 年 8 月 JOURNAL OF HEFEI UNlVERSITY OF TECHNOLC后Y Aug. 2013 Doi: 10. 3969/j. issn. 1003-5060.2013.08.001 典型电动车窗控制系统的规则化描述建模 卫星l ， 3 ，袁猛猛2 ，吴燎原1 ，张利2 ， 3 (1.合肥工业大学计算机与信息学院，安徽合肥 230009; 2. 合肥工业大学机械与汽车工程学院，安徽合肥 230009; 3. 安全关键工 业测控技术教育部工程研究中心，安徽合肥 230009) 摘 要:针对传统控制方法不能满足人们对于汽车日益提高的安全性和舒适性要求，文章提出了一种基于规 则化建模的车窗控制策略，系统采用专用车身控制器CBCM) ，利用规则式描述车窗行为关系并以此建立系统 模型，根据输入信号，控制器直接调用规则库对其匹配并输出控制信号。以某款车型的部分控制系统为实例 进行仿真实验，仿真结果表明，该车窗控制方法降低了系统的延时性，将系统的实时性提高了约 30%。 关键词:车身控制器;规则化描述;车窗控制系统;延时性 中固分类号:TP391. 8 文献标志码:A 文章编号: 1003-5060(2013 )08-0897-06 Modeling of typical power window control system using rule description method 1 3 1 WEI Xing • , YUAN Meng-ment , WU Liao-yuan , ZHANG LF 3 (1.Sch∞1 of Computer and Information , Hefei University of Technology , Hefei 230009 , China; 2. School of Machinery and Automobile Engineeri吨， Hefei University of Technology , Hefei 230009 , China; 3. Engineering Research Center of Safety Critical Industrial Meas- urement and Control Technology of Ministry of Education , Hefei 230009 , China) Abstract: Considering that the traditional method can not satisfy people s increasing requirements of automobile safety and comfort , a strategy of window control based on the rule description modeling is put forward. The body control module(BCM) is adopted for vehicle controller , and the rules are used to describe the relationship of window behavior and establish the system model. According to the in- put signal , the controller directly calls rule base to match and output control signals. The simulation experiment on part of the control system of a type