理想gr机型（Ideal GR model）.docVIP

理想gr机型（Ideal GR model） The ideal GR models T1/E01 main motor lock, display and interrupt machine (1) in the main motor starting after 2 seconds, the A position The sensor can still be detected by the position of the roller A (2) in the main motor starting after 5 seconds, the position sensor A A failed to detect the position of the roller press the full recovery button T2/E02 lifting motor lock, display and interrupt operation of the machine (1) the lifting motor starting up feed after 9 seconds, the action block limit position sensor not lift lifting device (2) the lifting motor starting down feed after 9 seconds, the light path lower lifting device is not blocking sensor (3) in the lift starts up feed after 2 seconds after the optical limit lifting device sensor is still blocking (4) starting in late fall into the lifting motor after 2 seconds, the lower limit of the action block lifting device sensor still raised by pressing the full recovery button T3/E03 the first version of the clip fault display and interrupt operation of the machine (1) version of the clip (connected) coil activated for 4 seconds, Action block version of the clip safety switch is still under pressure (2) in the release version of the clip coil (Guan Diao) after 4 seconds, Action block version of the clip is not under pressure safety switch (3) the clamp motor begins to rotate after 8 seconds, angle The temperature sensor (0 and 180) did not detect the angle of magnet (4) in the version of the clip coil is not in operation, the version of the clip Action block safety switch is not under pressure to press the full recovery button T4/E04 ink overflow, display and interrupt the machine operation if the ink spill sensor in the detection device to squeeze The ink ink spill off sensor T5/E05 printing position of the motor is locked, and interrupt the display machine in printing position of the motor begins to rotate after 12 Second, if the center vertical sensor state is not to break through (or sw