《塑料成型工艺及模具设计》试卷二)（Plastic forming technology and die design examination paper two）.docVIP

《塑料成型工艺及模具设计》试卷二)（Plastic forming technology and die design examination paper two） Plastic molding process and mold design paper two Out of 100 points, the examination time for 150 minutes First, fill in the blanks (each 1 points, a total of 30 points) There are two methods and 1, preparation of synthetic resin. 2, there are three kinds of plastic but different physical state in the process of change:,,. 3, for the benefit of plastic mold, plastic side structure should avoid setting or. 4, in order to make the mould structure is simplified, in general, to make plastic parts in the mold after kept in or on. 5, a clamping mechanism setting precision positioning device is designed to hold the mold side cone when the mold cavity on the other side, to the effect of the cavity on. 6, injection molding need to control the temperature of temperature, temperature and temperature. 7 and a half compression die cavity type overflow charging set at. The excess material pass Then remove storage. 8, from the heat transfer area, thermosetting plastic injection mold runner section should be used; thermoplastic injection Die runner section shape should be used. Considering the easy processing, plastic injection mold used to shape and shape. 9, for a mold injection molding machine can mold clamping equipment, need to compare the die size (technical parameters), (parameters). 10 axis, the sprue is generally located in the mold, its axis and the injection machine weight He. 11, on the direct gate (also called the sprue gate) core end is provided with a pit, the pit is called, The effect is to make the melt. 12, in order to control and prevent the plastic molding or in use process, because of the heat, light, oxygen and other effects and degradation, oxidation, chain chain breaking phenomenon resulting in destruction, adding. Two, single choice (1 points per day, a total of 10 points) 1, the following belongs to plastics thermosetting plastics (is). A, B, C, ABS, polyethylene, nylon D re