bios恢复默认值（BIOS restores default values）.docVIP

bios恢复默认值（BIOS restores default values） BIOS restores default values Boot press DELETE button to enter BIOS, in Load, Default, Configuration, Load, Optimized, Configuration, these two, select which of which can be reduced to factory settings, do not forget to save F10 exit. The load fail-safe defaults loads the CMOS default value of the bios. The load optimized defaults loads the default COMS value of the optimized, and this setting is relatively useful for setting the speed of the main board. Generally speaking, the two, can not find the previous one, behind the line, see the different brand setting method of the motherboard is different, but the same ah. If you like hands-on, physics settings are most direct ~! Take down the battery on the motherboard directly, and then install it to restore it! There are usually two ways A: the old motherboard may only install the motherboard battery back, it has cleared the CMOS memory effect Two: new motherboard (usually after 2004), should be used to clear the CMOS jumper, you just jump the cap to pick up, you can BIOS in one or two DEFAUT options, LOAD once you can, and do not have much trouble The above 1 and 2 answer need to disassemble the box, more troublesome; third answer also did not say very clear, for computer beginners, a bit difficult; the following is my answer: for all applicable: Boot, and so on when the display of English, and constantly press the keyboard on the Del key or Delete key, enter the BIOS settings interface, to find load, Optimized, Defaults entries, this item means restore factory settings.. Move the cursor to the item with the arrow keys, press the Enter key, then move the cursor to Save Exit Setup, press the Enter key, and appear in the dialog box The back is Y, and if N, press Y directly, then enter. At this time to complete; if it is to display the BIOS menu interface, directly move the cursor to the Exit menu, below one for Load Setup Defaults, press Enter button, select Exit Saveing Chang cl