pcb制作事项（PCB making matters）.docVIP

pcb制作事项（PCB making matters） This article is contributed by huangzushui DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. The 1. principle of common mistakes: (1) ERC report no access to signal pins: A. to create a package to the pin at the I/O attribute is defined; create B. components or modify components placed grid attributes are not consistent, and the lines do not pin connection; C. create components reverse direction when the pin, must be non pin name end connection. (2) components went to the drawings profession: failed to create a component in the component library graph paper center. (3) the construction file network table can only be partially transferred to PCB: when generating netlist, there is no selection for global. (4) when the number of parts to use to create their own components, do not use common mistakes in annotate. 2.PCB: (1) the network load report NODE not found: A. principle diagram of the components was not used in the PCB library package; B. principle diagram of the components used in the name of the PCB library is not consistent the package; C. principle diagram of the components using the pin package number inconsistent PCB library. Such as transistors: pinnumber, e, B, C, sch, while PCB is 1, 2, 3. (2) print can not always print to a page: A. PCB library to create is not at the origin; B. multiple moving and rotating components, the PCB board has a hidden character out of bounds. Select to display all hidden characters, reduce PCB, and then move characters to the border. (3) the DRC report network is divided into several parts: the network is not connected, the report file is read, and the CONNECTED COPPER lookup is used. In addition to remind friends to make use of WIN2000, reduce the chance of a blue screen; several export documents into the new DDB file to reduce the file size and PROTEL dead opportunity. If you have a more complicat