电主轴说明书（Electric spindle manual）.docVIP

电主轴说明书（Electric spindle manual） JGD series water cooling electric spindle usage manual Thank you for purchasing our products, in order to better understand and use the JGD series water-cooled electric spindle, and correctly install and maintain this product, please read the instruction manual carefully before installing. Grasp the performance of JGD series water-cooled electric spindle, then install and debug. Preparation before installation 1, JGD series water-cooled electric spindle working environment temperature is usually -10 ~ 40 degrees centigrade. 2, before installation, first hand rotating spindle head, should feel flexible, no blocking phenomenon. 3. Check the stator insulation resistance with 500Vs shake meter not less than 100M. 4. The electric spindle which meets the requirements above shall be installed in the machine frame, and the spindle housing shall be in sliding fit with the mounting holes of the machine base. The motorized spindle shall not be clamped in the front and rear bearing parts to prevent the deformation of the bearing chamber. The bearing will be stuck and the bearing will be damaged early. Clamping force should not be too large, motorized spindle into the base, shall not be loose. Two, the correct use 1 、 according to the requirements, connect the electric spindle inlet and outlet pipe joint, check whether the connection is leaking and unobstructed. Switch system of cooling system water cooled spindle in machine tools should be connected to the middle; boot shutdown, cooling system should work continuously; the cooling liquid water is calculated by 2.5 liters / kW / minutes, coolant flow by 3 ~ 6 liters / min, small electric spindle for small value, large electric spindle large value; require the use of separate coolant tank, coolant required monthly change; the coolant temperature should be lower than the ambient temperature 3 ~ 5 degrees is appropriate, the best control in 25 degrees celsius. 2, select the frequency converter and th