电路可靠性设计（Circuit reliability design）.docVIP

电路可靠性设计（Circuit reliability design） Recently a little busy, all ran, and studied the situation of product technology in some enterprises, a relatively common phenomenon is that R D personnel without exception in condemning the procurement and Technology Department, the components of strict control, resulting in the qualified rate is low, to the customer site frequently with circuit board. Citing many examples and literature experts speaking to support his argument, and I hope I can sing a few words, can take to the relevant material and manufacturing departments apply a bit of pressure, but in the end I let them down. I give the conclusion, without exception, is the head of research and development. And to research the brothers several points of view: in the company, R D team strong enough, will not be added by me that broke the camels last straw; the product reliability level and R D strength is inversely related to the circuit design and device error; improper application accounted for 80% of the fault factors. Take a few simple examples: an electrolytic capacitor is next to a heat sink, and the part of the circuit that is associated with the electrolytic capacitor is prone to drift, and the result is instability of the machine parameters; Green LED color is not the same, looks not beautiful, luminous tube has a wavelength, even green wavelength will lead to subtle differences in color, while the design documents did not make provisions on the wavelength of light tube; A circuit work is not good, it is found that the PCB board signal line of an inductor into magnetic beads is good, so it changed the BOM single, on the circuit board with a bead, wantonly produced. The conventional understanding of it, and the inductance characteristics of magnetic beads seem to is the same, but in fact the bead is a frequency dependent resistance is expendable, and the inductance is the energy storage characteristic of the storage is peak. Even from the actual results, it seems