擦色漆的工艺（Process for polishing paint）.doc

擦色漆的工艺（Process for polishing paint） Process for polishing paint Hthread-165719-1-1.html A paint brush, closed: Roughstuff, surface color, shading, sheet sheet pores, transparent varnish. 1, with 360# sand paper edge, burr and other white embryo processing, requirements along the decorative panel texture grinding, strictly prohibited by texture transverse grinding. 2, brush closed primer, 1:0.5:1.6~2.0 ratio (Main: solid: thin), uniform thickness requirements, no flow hanging, no coarse particles and other defects, 1 hours in summer, 3 hours in winter can be carried out to the next step. 3, with water atoms ash full scraping, color by color. 4, with 360 sandpaper polished, along the decorative panel texture grinding, strictly prohibited by texture transverse grinding, no burr, no gray scar, ash clean up. 5, wipe the color, brush with wool brush on the surface of the brush, after wiping the toner, wipe with a cloth along the texture evenly, clean, no flow hanging. 1 hours in summer, 3 hours in winter, you can do the next step. 6, spray PU primer: 1:0.5:0.6~0.8 (main agent: curing agent: thinner), requiring uniform thickness, fullness, no particles, no flow, hanging and other defects. 7, fill ash: fill needle, fill in the primer surface shrinkage, dry, summer 2 hours with the oily putty to rub together, gray color, color and other prohibited. 8, with 360 sandpaper grinding: grinding, and 600 with sand marks, for closing molding, no dust, no burr, no scar, no dust, no pinhole highlights, along the decorative panel of the polished texture, the texture is strictly prohibited in accordance with the horizontal grinding, not worn roughstuff. 9, repair color: with a brush to rub the bottom of the brush color repair, after repair color, The ratio of 1KG and the end of the Qing main paint complexion sperm 50G - 60G, 1:0.5:1.1-1.3 (principal: solid: dilute), 1.2 caliber gun color repair paint quantity and pressure is not too big, the gun and the surface at an angle of 45 degrees