数控试题3（NC test questions 3）.doc

数控试题3（NC test questions 3） Download NC questions free of charge I. judgment questions (1 points per subject, 20 points each) 1. There is no machining surface with geometric tolerances in the drawing, indicating that the machined surface has no shape and position tolerances. () 2, cutting parameters, the impact of cutting temperature, the maximum is the feed () 3 、 numerical control machine single work table, use the multi station jig, in the processing process, in order to improve the efficiency, may carry on the work piece loading and unloading. () 4, bue cold at the front, cutting can increase the rake angle, is conducive to cutting. () 5, because of the low bending strength of carbide, the impact toughness is poor, so the front angle should be less than the high speed steel tool reasonable front angle. () 6, the hardness of the tool material is higher, the strength and toughness are lower. () 7 and XK714 type milling machine, the model K means nc. () 8, when the frequency control motor is used to control the spindle running, the S instruction can be specified according to the revolutions per minute. () 9, all milling machine models, the main name for the work table width. () 10, X62W horizontal lifting table milling machine in the W that universal features, universal. () 11, in the milling machine with fixed connection method to install the reamer, if the reamer is partial pendulum, will make the reaming aperture worse. () 12, in order to ensure the shape accuracy, in the vertical milling machine before boring, should find the vertical axis of milling machine axis and work table verticality. () 13. When milling the forming surface of the end milling cutter, the diameter of the milling cutter should be determined according to the minimum external arc. () 14, in order to ensure the milling machine shaft transmission accuracy, support bearing radial and axial clearance, the smaller the better. () 15, when the milling machine table, a little resistance to stop feedin