水电部分（Hydropower section）.docVIP

水电部分（Hydropower section） 14 Electrical Engineering 14.1 basic requirements 14.1.1, the electrical Dianliao specifications should comply with the design requirements and the relevant countries in the current product standards, when the design requirements and national standards inconsistent current electrical products, should carry out the current national standard. Electrical installation personnel should be certified. 14.1.2 line, phase line and the zero line color should be different; the same residential wiring color should be uniform, line (L) to use the red, zero line (N) to use the blue line protection (PE) application of yellow green color line, plus the yellow green color cord. The copper core cross section of the socket should be no less than 2.5mm2, and the cross section of the copper core of the lamp holder and switch should be no less than 1.5mm2. Three phase five wire system, distribution design, uniform distribution. Load line diameter section should be chosen so that the wire safe carrying capacity is larger than that of the shunt in all electrical appliances and the rated current of the circuit, the load should ensure the normal use. 14.1.3 electrical wiring uses line laying must piping (except the cast-in-place concrete floor ceiling and the wall can be made of insulating hose), wire joints into the piping should be located in the junction box, the pipe should be closely connected, smooth, mouth mouth is complete, the total cross-sectional area of the wire in the tube (including insulating sheath) should not exceed the tube in section 40%. The conductor shall not have knot and kink in the pipe. It is strictly forbidden to lay wires directly without wearing tubes. Wires and telephone lines, TV cables and other communication lines shall not be installed in the same pipe. The distance between pipes shall be greater than 500mm. 14.1.4 distribution box shall be provided with leakage protection, earthing protection, short-circuit protection and overload p