调节池作用资料（Regulating pool action data）.doc

调节池作用资料（Regulating pool action data） Regulating pool, also called accident pool. The following functions are as follows: 1. Preliminary settlement and separation; 2, regulating water quality, water quality can be balanced, conducive to the next process; 3, adjust the amount of water. If the water inlet is not uniform, the pool can be adjusted 4. The function of accident buffering can be realized. If the process behind the emergence of small fault, waste water can be fleeting here, Play a buffer role, not as the production process, because the waste water can not be ruled out and stop, So its also called the accident pool. The function of the regulating pool is to regulate daily water and water quality, because the daily drainage and water quality are uneven, and the water treatment system is usually constant, . Therefore, the sewage advanced regulating pool, then after the pump to enhance the follow-up unit processing District sewage is different from municipal wastewater (usually including some industrial waste water), and belongs to the scope of domestic sewage. The characteristics of water quality and water quantity can be summarized as follows: the water quality and quantity of water changes greatly, and the concentration of pollutants is low, that is, it is lower than urban sewage, and the sewage has good biodegradability, and it is difficult to process . The treatment process of district sewage varies according to the function of sewage discharged into the water body, and the commonly used treatment methods are: septic tank, primary treatment (primary sedimentation tank) Two biological treatment and two stage treatment, and then disinfection, reuse and so on. Due to the small amount of sewage treatment, the management level is not high, Therefore, in the process design, as far as possible the use of no sludge or less sludge treatment process, in order to prevent poor sludge treatment caused by two pollution. At present, the commonly used treatment processes ar