寺岗80称设置1（Temple Gang 80, set 1）.docVIP

寺岗80称设置1（Temple Gang 80, set 1） Temple Kong said models 80, 90, 100 related settings Model: SM-80PCS SM-90PCS SM-100 The model can be viewed on the left side of the nameplate or on the keyboard Country version initialization Note: 1, the new scale must set the basic functions. 2, after finishing the national version, you must set the basic functions. 3, the national version will clear the system settings and function settings, so the general situation is not easy to do. 1, four [Methods] into Z mode, and then open the switch at the bottom of the calibration scale (with a cotton swab gently next to) 2, and then press and hold [zero] not put at the same time enter [8822] screen appear SPEC 3-CN COUNTPY input [3] (3 represent Chinese version), and then [Print], the screen appears SPEC, Y-C, N-T, and then press [clear] 3, the screen appears SCALE TYPE with [X] button to switch the machine type POLE (with arm display).BENCN (platform scale).ELEVATE (EV).HANGING (hanging). SELF-S (S scale). CASSE-B (old 80/90BCS). CASSE - P (old 74 key 80/90PCS). B-CS (platform scale, 80/90BCS platform scale). P-CS (with arm 80/90PCS) PCS (PCS) select, press [Print], and then [X] key switch range 15KG, and then [Print], and then [X] key select 1/7500S, [Print] confirm and save settings. 4, press [clear] key to clear memory, etc. in a few seconds, the system will automatically return to the Z mode, two times [way] exit. The national version will clear the system settings and function settings, so its not easy to do it in general. After the version of the country is initialized, you need to reset the 141 and 142 functions. Basic function settings One, 141 function settings Enter settings: four times [mode], then press and hold [zero], lose at the same time [141], then refer to the following table, operate as follows: 1, SPEC00X4 single item bar code is set as: F1F2CCCCCXXXXX, C/D 2, SPEC24X16 single label format is set to format 1 3, SPEC49X2 communication mode is Ethernet twisted pair 4, S