宽带网线 水晶头（Broadband network crystal head）.docVIP

宽带网线 水晶头（Broadband network crystal head） Fabrication of 1. through RJ-45 joint The first step: twisted pair cable clamp (of course, also can use other tools to cut the line) is a category five twisted pair of cut (best first cut a line with the required length, then cut cable) Qi is inserted into a gap in the cable clamp for wire, cable that can not bend into the line. The cable clamp, until the counter behind the gear, a hold line clamp a slowly rotating circle (no need to worry about the damage inside the cable core wire wrapping, because there is a certain distance between the two blade stripping left this distance is usually 4 of the diameter of the core), knife cut protection rubber twisted pair. Pull off rubber. As shown in the following figure. Of course, also can use specialized tools to peeling wire stripping. [tip] cable clamp gear from the stripper blade length usually just as the length of the crystal head, which can effectively avoid stripping too long or too short. Stripping a long unsightly, on the other hand is crystal head stuck, because the Internet can not easy to loose; stripping too short, because the foreskin is too thick, there can not be completely inserted into the bottom of the crystal head, causing crystal head core wire and cable pin can not be good contact, certainly not making success. The second step: stripping except the foreskin, you can see the twisted pair cable network of 4 pairs of 8 core lines, and you can see that each pair of colors are different. Each pair of twisted wires is composed of a core with a corresponding color and a white core with only a little bit of the corresponding color. The color of the four panchromatic cores is brown, orange, green, blue. The first 4 of the core word line are arranged side by side, and then separate each of the core line (at the same time, careful not to cross the line arrangement, that is to say each of the core wire are arranged adjacent to), and according to the unified arrangement (su