建筑复习题（Architectural Review）.docVIP

建筑复习题（Architectural Review） Engineering surveying A volume Note: please write down the answer sheet on the answer sheet. First, fill in the blanks (2 points per hour, 10 empty, 20 points) The center angle of the 2mm arc length on the 1. level is called the dividing value of the leveling pipe, and the smaller the value is, the higher the accuracy is. 2., according to the distribution of the known level and the actual needs, the leveling route can be generally arranged into a leveling line, a closed leveling line and a support level route. 3. topographic surveys include control measurements and broken sections, and control measurements include plane control measurements and height control measurements. The methods of height measurement at 4. points include leveling, trigonometric leveling, and barometric leveling. 5. the continuous surface on the ground that is perpendicular to the direction of gravity is called the geoid. 6. in routine surveying, the basic measurements of ground points are distance measurement, angle measurement and height measurement. Two, multiple-choice questions (for each of the following alternative answers, only one with the correct answer. Please fill in the brackets after the answer you have chosen. This time 20 minutes, every day 2 points, a total of 40 points. Multiselect, wrong, not the election did not score) 1. in leveling, if the rear view A readings are large, and the readings of the forward-looking point B are small, there is (A). The A and A points are lower than the B points, and the B and A points are higher than the B points C, A, and B points may be the same height, D, A points, B points depending on the height of the instrument 2., the Gauss projection belongs to (C). A. equal area projection B. equidistant projection C. equal projection D. equal length projection 3., in the construction of various projects, the design of the design of the building location in the field of demarcation work is called (B). A. determination, B. con