斜齿轮齿轮建模（）.docVIP

斜齿轮齿轮建模（） Modeling of EX2.5 web type involute spur gear Finish $/clear $/prep7 1. definition of gear parameters -------------------------------------------------------------------------! M=2.5 $z=98 $refa=20 gear modulus, gear teeth number, tooth angle (i.e., the pressure angle on the circle) Hax=1 $cx=0.25 addendum coefficient, top clearance factor Rouf=0.38*m $ks=6 root radius and number of holes on the web ! following more than 1.1 calculated values, it is adjustable, but pay attention to the relationship between ------------------------- Ha=hax*m $hf= (hax+cx) *m! Top of the tooth, Chi Gengao Pi=acos (-1) - parameter pi D=m*z diameter of pitch circle Db=d*cos (refa*pi/180) - base circle diameter Da=d+2*ha$df=d-2*hf the diameter of the addendum circle and the diameter of the root circle Alfad=acos (db/da) - Addendum Circle pressure angle *if, DB, GT, DF, then, if the diameter of the base circle is greater than the diameter of the tooth crown circle Alfag=0.0$*else, make the root circle pressure angle of 0, otherwise Alfag=acos (db/df) $*endif the root of the tooth gets the circle pressure angle B=0.22*D the width of the teeth can be chosen according to the stiffness of the teeth and the relative position of the bearings 1.2 shaft hole parameter setting ----------------------------! Dta=6*m the gear thickness is generally (5~6) M Dax=d/5 the diameter of the axle hole can be set according to itself. Here is the diameter of the 1/5 circle D2=1.6*dax the diameter of the outer edge of the axle hole D1=0.25* (da-2*dta-d2) -- diameter of circular hole on Web D0=0.5* (da-2*dta+d2) -- the circular diameter of the center of the circular hole on the web C=0.3*b the web thickness is generally 0.3B Nj=0.5*m$nj1=0.5*m external chamfer and inner chamfer of axle bore R=5 the web chamfer radius S=1.5*dax! The shaft hole length, generally used (1.2 ~ 1.5) and DAX = b 2. create a tooth -------------------------------------------------------------------------------! 2.1 calculate th