浅谈钢筋工程的监理（Elementary introduction to supervision of steel bar project）.docVIP

浅谈钢筋工程的监理（Elementary introduction to supervision of steel bar project） Discussion on reinforcement engineering supervision.Txt are not afraid of thieves with tools, afraid of thieves! 1 taste life, perfect human nature. Being is opportunity, thinking can improve. People need to constantly break themselves, but should re assemble themselves. Elementary introduction to supervision of steel bar project Author: safety culture network article source: security culture outlets hit: 347 update time: 2007-10-12 Brief introduction: the reinforced material, specifications and types of welding should meet the design specification for reinforced construction engineering, material and product certificate and physical performance test for steel imports to increase the performance of chemical examination, inspection qualified rear can use. Key words: reinforcement engineering, supervision (1) construction technology 1, steel production Steel production, steel processing and to design review, check whether there is material errors and omissions for each bar to press the material table to check whether meet the requirements, after the two checks, and then press the sheet out of the samples, can be produced in batches before trial qualified, good steel processing to supervise the orderliness. In the construction of such as the need for reinforcement replacement, we must fully understand the design intent and substitution properties of materials, strictly abide by the provisions of the existing reinforced concrete design specification, steel reinforced high strength low strength and not by substitution of the area. The replacement of steel bars in important parts must be approved by Party A and the design unit and may be replaced by written notice. (1) steel surface should be clean, adhesion of oil, soil, floating rust, must be cleaned before use, can be combined with cold drawing process rust. (2) straightening of steel bars can be done by mechanical or manual straightening. The steel