不锈钢复合板如何焊接（How to weld stainless clad plate）.docVIP

不锈钢复合板如何焊接（How to weld stainless clad plate） (1) according to the exact solution of the unfolding dimension of the cylinder, the expansion length is calculated, and the actual cutting size is correct. (2) ensure the quality control of cylinder rolling, roundness. (3) the dimension of groove shall be marked with duplicate layer as the basis to ensure that the wrong edges are not exceeded. (4) the ring seam group adopts ring shaped radial tooling, which guarantees the roundness and ensures the quality of the group. (5) the head and the cylinder block pair, first of all guarantee their mesh degree, and then match the perimeter of the cylinder with the circumference of the head to ensure the quality of the head and barrel. (6) the group is based on the composite layer, so as to prevent the wrong edge of the composite layer from exceeding the standard. 6. welding welders Engaged in welding work of boiler and pressure vessel welders must carry on the test formulated by the State Administration of Quality Supervision Inspection and Quarantine of the boiler and pressure vessel welding pressure arrow _I two exam and management rules, made the welders certificate, can work within the scope of the qualified welding project in the validity period. Welders must be welded according to drawings, process documents and technical standards. The welder shall make welders in specified parts of seal for the anticorrosion of stainless steel and composite steel pressure vessel shall be in anticorrosion and using hard imprint as welder identification mark, and the application of recording the welder code, and the quality of the products included in the sketch book provided to verify the user. 7. welding requirements In order to ensure the original comprehensive performance of the stainless steel composite plate, welding should be carried out at the base, transition layer and composite layer respectively. Stainless steel composite plate welding, should pay attention to the following points: