手机设计规范v4.doc3-28（手机设计规范 v4.doc3-28）.docVIP

手机设计规范v4.doc3-28（手机设计规范 v4.doc3-28） This article is contributed by huang_business DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. Mobile design benchmark Mobile phone thickness analysis Mobile design essentials: flip top: flip top: Directions: 1) A and B cover coordination: decorative line gap 0.2mm; Icon: 2) near the front position of the shaft and the best two screws on the lock shell (shaft end is a must), rest on the buckle assembly, both sides of the 2, the rabbet size is 0.6*0.7 (high), the parent check port and the public space for 0.05/, check with the mouth and buckle position. 3) cutting clearance lens and shell 0.07mm/, injection lens value of 0.1mm. bottom to do 0.12mm adhesive fixed on the housing around the gap narrowed 0.2mm/ unilateral, space 0.15mm. 4) plating and shell clearance of 0.1mm/ side, bottom glue cooperates with the housing, if do hot on fixed form, the LCD module must be grounded with copper foil, conductive sponge will plating grounding (hole on the shell). 5) the sponge and the shell are glued together, and the small side is made of 0.2mm. The design of sponge should not be less than 1/2 of the sponge thickness. Selection of location: upper and lower display, camera FPC, SPEAKER, headphones, vibrators and other fixed, specifications are thick 1, 0.8, 0.5, 0.4 and so on. 6) the LCD module cooperates with the shell: the LCD module is surrounded by a surround bone (0.6 thick) and can be opened and buttoned away from the place where the buckle is made. Around 0.5 degree taper 7) the coordination of the hinge and the shell: the opening of the shell and the hinge take 0-0.02mm at one side, pull out and take 0.0-0.2 degrees. The bottom end of the rotating shaft of the hinge should keep 0.5mm distance from the outer end of the shell, as shown in figure. 8) the length of the FPC cross line slot is FPC from the end face of the 1.0mm, and the w