三相电压源逆变器的三次谐波注入PWM调制算法.docVIP

文章编号：0258-8013 (2009) 07-0001-06 中图分类号：TM 85 文献标志码：A 学科分类号：470·40 陈强 （上海交通大学，上海市东川路800号 200240） Chen Qiang (Shanghai Jiao Tong University, 800, Dongchuan Rd, Shanghai, China, 200240) ABSTRACT: This paper analyses　the theory of the triple harmonic insertion PWM modulation algorithm of a three phases VSI , and proofs why the optimal factor is 1/6 for three order harmonic insertion PWM for a VSI. Results of the simulation by Matlab/Simulink are shown. KEY WORDS：triple harmonic insertion PWM modulation algorithm; three phases VSI; 1 The triple harmonic insertion PWM With the three-phase sine wave inverter is widely applied, the research on three-phase Inverter is also increasingly in-depth. If the expected three-phase Inverter output current is without distortion, which requires the output voltage harmonic content especially low-order harmonic content as low as possible, so only do without distortion in theory, which is to ensure the peak amplitude of the desired output phase voltage less than or equal to the amplitude of the input voltage, the equivalent of insufficient power supply. The objective function of the triple harmonic insertion PWM modulation algorithm is a fundamental sinusoidal function combined with a triple harmonic function, whose amplitude is 1/6, instead of only a fundamental sinusoidal function. Excluding assumed dead band, the output phase voltage effective value is equal to the DC circuit voltage, maximum voltage utilization increases, so greatly reduced the proportion of harmonics, and the third harmonic line voltage is zero, which greatly reduces the harmonic hazards. The objective function of the triple harmonic insertion PWM modulation algorithm is a fundamental sinusoidal function combined with a triple harmonic function, whose amplitude is 1/6, instead of only a fundamental sinusoidal function, as Fig.1 shows. Fig.1 One of target functions of third harmonic injected PWM The amplitude of the triple harmonic function which is inserte