高强度风电螺栓用钢的低温冲击韧性研究.pdfVIP

高强度风电螺栓用钢的低温冲击韧性研究 ·1 · 高强度风电螺栓用钢的低温冲击韧性研究 1,2 1,2,3 1,2 1,2 1,2 陈继林 刘振民 崔 娟 张治广 蔡士中 （1. 邢台钢铁有限责任公司，河北邢台 054027 ；2. 河北省线材工程技术研究中心， 河北邢台 054027 ；3. 北京科技大学材料学院，北京 100083 ） 摘 要 结合实际轧制过程，运用金相显微镜、SEM、TEM ，及低温冲击功试验，研究了高强度风电螺栓用钢 B7 的低温冲击韧性研究，结果表明：采取低温轧制，材料组织均匀性较好，多边形铁素体均匀分布；有助于位 错密度的改善;在低温轧制工艺下产品内部大角度晶界角度要偏小；产品晶粒度较高，达 8 级。实验证明：通过 低温轧制，内部组织的改善有效降低了材料韧脆转变温度，并提高组织晶粒度，最终实现了 B7 产品低温冲击韧 性有所提高。 关键词 高强度，低温冲击韧性，低温轧制，晶粒度 Research on Low Temperature Impact Toughness of High Strength Wind Power Bolt Steel Chen Jilin1,2, Liu Zhenmin1,2,3, Cui Juan1,2, Zhang Zhiguang1,2, Cai Shizhong1,2 (1. Xingtai Iron and Steel Corp., Ltd., Xingtai Hebei 054027, China;2. Hebei Engineering Research Center for Wire Rod, Xingtai Hebei 054027, China;3. University of Science Technology Beijing, Beijing 100083, China) Abstract Combined with the actual rolling process, the low temperature impact toughness of high strength steel B7 was studied by means of optical microscope, TEM, SEM and low temperature impact test. The results show that: low temperature rolling, microstructure uniformity of polygonal ferrite, uniform distribution; help to improve the dislocation density; in the low temperature rolling process under the angle of large angle grain boundary to small grain products; a higher degree, up to 8, Experiments show that: the low temperature rolling, improvement in the internal organization to effectively reduce the ductile brittle transition temperature, and increase the grain size, finally realized the impact toughness of B7 products has increased. Key words high strength, low temperature impact toughn