注塑模具论文-某型多媒体音箱箱体成型模具设计.pdfVIP

淮 工 学 院 毕业设计说明书（论文） 作 者: 学 号： 学 院: 机械工程学院 专 业: 材料成型及控制工程 题 目: 某型多媒体音箱箱体 成型模具设计 指导者： 讲师 (姓 名) (专业技术职务) 评阅者： (姓 名) (专业技术职务) 2015 年 6 月 毕业设计说明书（论文）中文摘要 本文介绍了某型多媒体音箱箱体成型模具设计的设计过程。运用PRO/E进行 型芯型腔以及模架的设计，通过AutoCAD绘图软件对模具的结构进行了全面的描 述。本文对注塑机进行了选择和校核，对该塑件进行了结构分析和成型工艺的分 析，并且在文中对注射模具的成型部分、浇注系统、导向机构、脱模机构和温度 调节系统等进行了的详细的分析与设计。本次设计的难点主要是产品的造型设计， 以及塑件的型芯组合设计，冷却水道的设计。 关键词 音箱箱体，成型模具，导柱，PRO/E，AutoCAD 毕业设计说明书（论文）外文摘要 Title AdvanceofstudyonDesignMethodsofHydraulicSystemof RadioRemoteControlofConstructionMachinery Abstract The workingprinciple of radio remote controlling of construction machinery should be that signals of the radiowave from thetransmitter obtained in the receiver werecontrolled and then changed into electronic an alolor dgitalsignls which canbeused to drive different actuators and mechanismsof thevehicle.T hevehicle could be acted by following the controlling instructions sent by the operator.Thebest operation mode of constructionmachinery is suitablenot only to manual operating but also to remote controlling in the same vehicle The. design methodsof thehydraulic system usedfortheradioremotecontrolling of construction machinery are discussed The design methods of hydraulic circuits. for the actuators controlled by solenoidn off type valves, hydro-elect ronicmuti-way proportional valves, closed loop pro portonal servo driver o r three-way proportional reducing valves are discussed in detail ( with r ea l ex