基于ARM的GSM网络远程控制系统设计.doc

广西工学院 毕业设计（论文）说明书 课题名称 基于ARM的GSM网络远程控制系统设计 系 别 电子信息与控制工程系 专 业 班 级 学 号 姓 名 指导教师 2009年 06月 03日摘 要 利用GSM网络覆盖范围广、稳定性好和运行成本低等优点，结合目前流行的嵌入式系统技术，设计了一种基于ARM的GSM网络远程控制系统。本文详细介绍了系统的硬件设计。系统包括主控制模块和从控制模块两大部分。其中，主控制模块主要由ARM微控制器LPC2114、工业GSM模块TC35i及315M无线收发模块组成；从控制模块主要由STC89C52单片机和315M无线收发模块组成。 同时，本文给出了详细的程序流程图以及思路，为了使系统具有很高的实时性、稳定性和可靠性，本系统主控制模块以μC/OS-II操作系统为软件平台进行软件设计。通过设计，该系统可以通过手机短信进行远程控制3路电灯和1路4相步进电机，并返回相应的控制信息，电灯和步进电机的运行相互独立，互不影响，整个系统操作方便，具有良好的稳定性、可靠性和扩展性。 he GSM network has wide coverage, good stability and low operating costs,and combined with the prevailing technology of embedded systems,designed a GSM networt remote control system which is based on ARM.This paper describes the design of this system’s hardware.This system includes two major parts:the master control module and slave control module.Among them,the master control module build up with the ARM microcontroller LPC2114, the industrial GSM module TC35i and the 315M wireless transceiver modules; and the slave control module build up with the STC89C52 single-chip and the 315M wireless transceiver modules. At the same time, this paper presents a detailed flow chart of procedures, as well as ideas, in order to make the system has high Real-Time ability,stability and reliability, the system’s master control module use μC/OS-II operating system software platforms for software design. Through the design, the system can be carried out through the SMS remote control 3-way lamp and 1 way 4-phase stepper motor, and return the corresponding control information, lamp and stepping motor running independent and no interaction of each other, the whole system easy to operate, has good stability, reliability and scalability. Key words: LPC2114 GSM STC89C52 315M wireless transceiver modules μC/OS-II 目录 1 绪论 1 2 系统方案设计 2 2.1 设计任务 2 2.2 系统方案