钻井现场施工指令.pptVIP

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * GAME PLAN 主 要 内 容 一、 概述 二、 开钻前验收 三、 一开作业 四、 二开作业 五、 三开作业 六、 四开作业 七、 五开作业 八、 完井作业 六、四开作业 CLEAN DRILL TO KO POINT ： P/UP RIH W/ 8-1/2 BIT WITH BHA AS FOLLOWS: 8-1/2BIT+8-1/2 NBRR+1 X 6 1/2 DC+8-1/2 STRR+2 X 6 1/2 DC+X/O+6 X 5 HWDP+JARS+ 9 X 5 HWDP CONT RIH TO TOP OF DV，D/O CMT DV W/ WTR TEST DV TO 2000 PSI W/ WTR CONTINUE RIH TO F/C DRILLING FLOAT EQUIPT DRILL OUT CMT, BAFFLE PLATE FC CMT PT CSG TO 2000 PSI W/WATER CONT DRILL OUT CMT FS TO 3568 W/ WTRDRILL 8-1/2 HOLE TO KO POINT DEPTH DROP GYRO SURVEY AND POOH 六、四开作业 DIRECTIONAL DRILLING ： PICK UP 8-1/2“ PDC BIT SPERRY SUN TOOLS TEST TOOLS RIH DIRECTIONAL DRILLING 8-1/2 HOLE WITH WATER TO 7 CASING POINT IN ARAB-D RESERVOIR CHECK FOR FLOW HAVE ENOUGH VOLUME OF MUD @ 64 PCF PRIOR TO DRILLING ARAB-C RESERVOIR IF ANY INDICATION OF H2S OR OIL/GAS TO SURFACE HOLE WILL BE DISPLACED TO 64 PCF MUD 六、四开作业 DRILLING TO 7” LINER POINT ： AT LINER SETTING DEPTH, THE WATER WILL BE DISPLACED BY FRESH MUD PUMP 50 BBL HV MARKER AND CIRC HOLE CLEAN SPOT 100 BBL HV-PILL ON BOTTOM FLOW CHECK WIPER TRIP TO 9 5/8 SHOE BACK REAM OUT OF HOLE (IF HOLE TIGHT) REPORT FOR ANY TIGHT SPOT REAM TIGHT SOPTS WHEN BACK ON BOTTOM PUMP 50 BBL HV MARKER PILL AGAIN AND CIRCULA THE HOLE CLEAN SPOT 250 BBL OF TREATED HVP ON BOTTOM, SLUG POOH, L/D JARS, SPS TOOLS BIT 六、四开作业 RUN LINER ： Change Top Pipe rams with 7 Rams and Test BOPE Rig Up Liner tools HPJSM Pick up and RIH with 7 liner as per casing tally Float Shoe Collar will be tacked welded Test Float Shoe Float Collar with water at V-Door Bake lock first 4 joints Fill every joint for first 10 jts, Then every 10 joints with 64 PCF mud using TDS When 7 Casing reach 9-5/8 Shoe, P/U Circulating Head Circulation Bottoms up +/- 110 bbls w/64 PCF mud 六、四开作业 RUN LINER ： Continue run liner Make up 7 Baker Liner Hanger Assembly and circulate Liner capacity (+ I/- 220 bbl) with mud and record liner weight (slac