S7-200英文.docVIP

The S7-200 equipment is designed to be easy to install. You can use the mounting holes to attach the modules to a panel, or you can use the built-in clips to mount the modules onto a standard (DIN) rail. The small size of the S7-200 allows you to make efficient use of space. You can install an S7-200 either on a panel or on a standard rail, and you can orient the S7-200 either horizontally or vertically. Separate the S7-200 Devices from Heat, High Voltage, and Electrical Noise As a general rule for laying out the devices of your system, always separate the devices that generate high voltage and high electrical noise from the low-voltage, logic-type devices such as the S7-200. When configuring the layout of the S7-200 inside your panel, consider the heat-generating devices and locate the electronic-type devices in the cooler areas of your cabinet. Operating any electronic device in a high-temperature environment reduces the time to failure. Consider also the routing of the wiring for the devices in the panel. Avoid placing low voltage signal wires and communication cables in the same tray with AC power wiring and high-energy, rapidly-switched DC wiring. Provide Adequate Clearance for Cooling and Wiring S7-200 devices are designed for natural convection cooling. For proper cooling, you must provide a clearance of at least 25 mm above and below the devices. Also, allow at least 75 mm of depth. Tip:For vertical mounting, the maximum allowable ambient temperature is reduced by 105 C. Mount the S7-200 CPU below any expansion modules. When planning your layout for the S7-200 system, allow enough clearance for the wiring and communication cable connections. For additional flexibility in configuring the layout of the S7-200 system, use the I/O expansion cable. Power Budget All S7-200 CPUs have an internal power supply that provides power for the CPU, the expansion modules, and other 24 VDC user power requirements. The S7-200 CPU provides the 5 VDC logic power needed for