计算机网络第四章题库.docxVIP

Chapter 4Which of the following is a characteristic of fiber-optic cable?( D)It uses an intense incandescent lightIts core is made of highly reflective KevlarIt relies on total internal cancellation to guide light for long distances It is capable of higher data rates than other types of networking mediaWhich of the following describes attenuation?(A)A.A loss of signal strength B. An increase in signal amplitudeC. The delay experienced during signal travelD. The time it takes a signal to teach it destination3. Which of the following is a cause of crosstalk?(A) A. Poorly terminated network cablingB. The loss of a signal‘s ground referenceC. AC line noise coming from a nearly video monitor or hard disk drive D. FM radio signal, TV signals, various types of office equipment 4. Which of the following are tests specified by the TIA/EIA-B standard for copper cable?(C.E.F)A. signal harmonics B. Conductive responseC. Wire map D. Signal absorptionE. Insertion loss F. Propagation delay5. What are three distinct kind of crosstalk?(A.B.E)A. NEXT B.PEXTC. ANEXT D.SPNEXTE. PSNEXT6. In designing a network, what would be used to calculate an optical link loss budget?(C)A. Amount of data lost during impendence mismatch eventsB. Amount of attenuation signal loss that can occur before data becomes corruptC. Amount of signal power loss that can occur without dropping below receiver requirementsD. Total of amount of data that can be lost before regeneration of signal7. Which numbering system uses 2as its base?(C)A. Octal B. HexadecimalC. Binary D. ASCII 8. Which of the following describes a common function of a cable-testing device?(D)A. TDR test and detects faulty virtual circuitsB. TDR test provide information about the location of a cabling run C. Wire maps provide information abou