连续感应淬火的短轴类零件首尾连接处的屏蔽.pdfVIP

舍：金：舍：舍：全：金：金：金：r ～工艺一 e e e e e e e e e e o e D e e e 连续感应淬火的短轴类零件首尾连接处的屏蔽 尤亦凡．杨文俊 (上海工业大学嘉定通用机械有限公司，上海 201822) 摘要：在卧式感应淬火自动生产线上，采用“O”形感应圈对短轴类零件(滚柱)进行感应淬火，用目视法分 析了硬化层的形态。结果表明，前面滚柱的尾部和后面滚柱的头部硬化层均不均匀，前者局部过 深，后者局部过浅。这是由于滚柱首尾连接处的间隙对“0”形感应圈的磁场产生了屏蔽作用所致。 采用“兀”形感应圈后，基本消除了屏蔽影响，使滚柱整体获得均匀的硬化层。 关键词：连续感应淬火；短轴类零件；屏蔽；硬化层；感应圈 中图分类号：TGl56．33 文献标识码：B Field inEnd·to—endZoneof MagneticShielding Brachy-axis-like Parts ContinuousInduction during Quenching YOUYi—fan．YAN Wen-jun General 201 (ShanghaiUniversityJiading MachineryCo．，Ltd．，Shanghai822) Abstract：The an coilinthe brachy-axis—likeparts(rollers)werecontinuouslyinduction-quenchedby 0-shaped horizontalautomatic lineforinduction hardenedcase ofrollerswere production quenching．The profile analyzedby meansofvisualization．Theresultsrevealthatthehardenedcasesattheendofforerollerandattheheadoffollow． rollerare hardenedcaseoftheformeris too the caseofthe and hardened ing nonuniform，thatis，the partiallydeep latteris too is the rollers onthe because betweentwo hasa effect shallow，which magnetic partially gap shielding field coil．When coilwasused．the effectwaseliminatedanduniform generatedby0一shaped n-shaped shielding hardenedcasewasobtained therollers． throughout